Data Loggers

Data Logger

Data Loggers: 
  • Data Logger
  • GPRS Based Data Logger
  • Automatic Weather Monitoring Station
  • Tide Gauge Formatter

Our Data Loggers address a wide range of applications, both for general and special-purpose stringent industry requirements. Our data loggers are tailored made and can be customized to meet your specific requirements. Special-purpose data loggers are available for temperature and humidity, voltage, thermocouple, and event applications to name just a few. Our Data loggers can be designed to be interfaced with USB, serial and parallel, Ethernet, Wireless, etc.

Specifications for Data Logger Elint Innovations-DL2014  

 

1.1 Processor and System

  • Micro Controller Kinetis – K60
  • Architecture :32bit ARM Core Cortex M4
  • Code Memory: 512MB
  • Date Memory : 128KB
  • Speed : 100MHz
  • Data Memory : 256Kbit (6 months @ 1Hr)
  • Operating Voltage: 9V to 15Volts DC
  • Operating Current: Below 120mA @12V
  • Quist Current : 1mA @15V, 2mA @ 9V
  • Op. Temperature : -20° to 60° Degrees
  • Op. Humidity : 0 to 100%

1.2 CONNECTORS

  • PC Communication : 9 PIN D-SUB Female
  • Data Communication : 9 PIN D-SUB Female
  • Power Supply : 2 PIN Phoenix Male

 

 

1.3 Analog Inputs

  • Resolution per Channel : 16 bit
  • Conversion rate : 480mSec
  • Reference Voltage : 2.5Volts @ ±1ppm
  • 4- 20mA Inputs : 4 Channels

1.4 GSM/GPRS

  • Network : Dual Band (2G)
  • Communication Server : FTP Protocol

 

Automatic weather station measures various meteorological parameters such as wind speed, wind direction, temperature, humidity and ambient pressure. The data collected in the weather station can be monitored on site or transferred to a remote server.

Automatic Weather Station Features:

  • It can be customized according to the application
  • Can be mounted on buildings, vehicles or tripod
  • Data can be output to a remote server using various means of communications 

The Tide Gauge reads the every minute data from Tide Gauge Sensor through serial port, processes them into a data packet. This data packet will be transmitted to the server through Satellite communication.

There are 2 modes of transmission. Mode 1 is One Minute mode data transmission and Mode 3 is Three Minute mode data transmission.

The System has advanced configuration settings which will be stored in Flash at two levels for more data reliability. The configuration and status requests could be done from Command Prompt.

This System has a serial port Command interface with intelligent debug application running to tell the system status and also responds to the commands from the user.